HindlePower Atevo Series Operating/Service Instructions Manual page 284
Microprocessor-controlled float battery charger three phase input 16-1000 adc output
Hide thumbs
Also See for Atevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (316 pages)
Table of Contents
Advertisement
HindlePower Inc
14.3.13.
14.3.13. Replacing MOV Surge
Suppressor Board (A9)
Suppressor Board (A9)
• For Style-5070, see also Service Instruction (JD5079-01).
• For Style-5030, see also Service Instruction (JD5079-02)
• For Style-163 & -198, see also Service Instruction (JD5079-02)
Steps:
• Shut down and lock out all power to ATevo.
• Remove safety shield, and check with a voltmeter.
• MOV Board (A9) is bolted directly to the ac input terminals.
• Remove the three (3) screws that connect the Transformer (T1) primary wire lugs to the
MOV Board (A9).
• Loosen mounting hardware, and remove old MOV Board.
• Install new (replacement) MOV Board (A9) onto I/O studs.
• Reinstall mounting hardware to secure MOV Board.
• Reconnect Transformer (T1) primary wires to MOV Board (A9).
• Reinstall three (3) screws through lugs that connect MOV Board (A9) to primary wires, and
tighten nuts.
• Replace safety shield, and close front panel door.
• Restart ATevo.
Copyright HindlePower Inc. 2021
Replacing MOV Surge
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Last modified: 13 September 2023
Page 284 of 311
Advertisement
Table of Contents
