HindlePower Atevo Series Operating/Service Instructions Manual page 248
Microprocessor-controlled float battery charger three phase input 16-1000 adc output
Hide thumbs
Also See for Atevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (316 pages)
Table of Contents
Advertisement
HindlePower Inc
13.2.
13.2. Forced Load Sharing – System
Forced Load Sharing – System
Requirements
Requirements
• All battery chargers must be ATevo Series. The ATevo forced load sharing feature will not
operate with legacy AT10.1 and AT30 Series battery chargers.
• All connected chargers must have the same voltage settings, have the same dc output
current rating, and have the same version of ATevo Main Control Board (A1) firmware.
• Each ATevo requires a 'FLS' Serial Communications Adapter (A13) to be installed in either
Port 2 or Port 3 of the Main Control Board (A1).
Copyright HindlePower Inc. 2021
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Last modified: 2 August 2023
Page 248 of 311
Advertisement
Table of Contents
