HindlePower Atevo Series Operating/Service Instructions Manual page 135

HindlePower Inc
6.1.7 Relays Icon 6.1.7 Relays Icon
Shows relay configuration and control options. Use it to configure relays and reset
or clear any latched alarm relays. To change a relay configuration, execute the
'Relay configuration' command then select the relay you wish to configure.
Refer to the following sections for details on:
• Changing Main Board Relay Parameters –
• Changing Auxiliary Board Relay Parameters –
• Resetting Latched Alarm Relays –
6.1.8 Aux Inputs Icon 6.1.8 Aux Inputs Icon
Used to configure Binary Inputs and Analog Inputs for up to four (4) Auxiliary I/O
Boards. Each board may have up to four (4) generic Binary Inputs and four (4)
generic Analog Inputs. See
Analog.
6.1.9 Testing Icon 6.1.9 Testing Icon
Displays the Battery Open Test configuration and controls. See
instructions on how to start, schedule, and set up parameters for the Battery
Open Test.
6.1.10 Communication Icon 6.1.10 Communication Icon
Used to configure optional communications ports. ATevo supports three serial
communications ports and one Ethernet port. The menu displays all ports, and
whether or not they are assigned and configured. Two (2) of the serial ports
support DNP3 and Modbus communications for SCADA applications. Refer to the
supplementary
6.1.11 Save|Reset Configuration Icon 6.1.11 Save|Reset Configuration Icon
Permits a system backup or restore using an optional SD memory card. All
configuration set points, alarm thresholds, and communications settings can be
stored on and retrieved from SD memory card. See
Copyright HindlePower Inc. 2021
Section 12.5
ATevo Communications Manual
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Section 4.5
Section 12.4
Section 7.6
for Binary Inputs, and
for port configuration instructions.
Section 6.5
Section 12.6 for
Section 7.7 for
for instructions.
Page 135 of 311