Preparing For Commissioning; Factory Settings - Siemens SINAMICS G115D Operating Instructions Manual

6.3

Preparing for commissioning

6.3.1

Factory settings

Motor
For the SINAMICS G115D Wall Mounted drive, the converter is pre-configured for an
asynchronous motor that matches the rated power of the converter.
For the SINAMICS G115D Motor Mounted drive, the following converter settings have been
set in the factory to the delivery condition to match the provided 2KJ8 geared motor.
Parameter
p1300[0...n]
p0300[0...n]
p0301[0...n]
p0541[0...n]
p0551[0...n]
p0601[0...n]
p1215
For more information about restoring settings to the delivery condition on the SINAMICS
G115D Motor Mounted drive, refer to the following section:
Converter interfaces
The inputs and outputs and the fieldbus interface of the converter have specific functions when
set to the factory settings.
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
Description
Open-loop/closed-loop control op‐
erating mode
Motor type selection
Motor code number selection
Load gearbox code number
Brake code number
Motor temperature sensor type
Motor holding brake configuration The value is automatically preassigned to "0" or "1"
Restoring the factory settings/delivery condition (without safety functions) (Page 126)
Factory interface setting (Page 82)
6.3 Preparing for commissioning
Delivery condition
20: Speed control (encoderless)
The value is automatically preassigned to "181" or
"602" dependent upon the selected SINAMICS
G115D Motor Mounted drive.
181: 2KJ8 asynchronous motor
602: 2KJ8 synchronous reluctance motor
The value is automatically preassigned dependent
upon the selected SINAMICS G115D Motor Moun‐
ted drive.
dependent upon the selected SINAMICS G115D
Motor Mounted drive.
0: No motor holding brake available
1: Motor holding brake according to sequence con‐
trol
Commissioning
107