Connecting The Cables In The Terminal Box - Siemens SINAMICS G115D Operating Instructions Manual

Additional information on the SIMOGEAR geared motor
12.2 Specific data motor
→
⇒
Figure 12-8
Table 12-11
Gearbox type
Z
D
FZ
FD
B
K
C
12.2.10.5

Connecting the cables in the terminal box

Note
Direct contact between the cable lug surfaces and the contact nuts ensures that the connection
can carry current.
In the case of terminals with terminal clamps, distribute the conductors in such a way
that the clamping heights are about the same on both sides of the fillet. This method of
connection requires a single conductor to be bent into a U shape or connected with a cable
lug. The same applies to the inner and outer terminals of the ground conductor.
Select the cable lug size according to the required cable cross-section and stud size. A
sloped / angular arrangement is permitted if the required clearances and creepage distances
are maintained.
Remove the insulation from the conductor ends so that the remaining insulation is almost
long enough to reach the cable lug.
456
View of output shaft
View of drive shaft / motor shaft
Direction of rotation
Direction of rotation of the geared motor when viewing the output shaft
View of
Output shaft
DE of the output shaft
NDE of the output shaft
DE of the output shaft
NDE of the output shaft
DE of the output shaft
NDE of the output shaft
Direction of rotation
Output shaft
Clockwise
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
Input shaft
Clockwise
Counterclockwise
Clockwise
Counterclockwise
Clockwise
Counterclockwise
Counterclockwise
Counterclockwise
Clockwise
Counterclockwise