Procedure
1. Only grease the inner friction surfaces of the shrink disks. To do this, use a solid lubricant with
a friction coefficient of μ = 0.04.
2. Use a paste containing MoS
underneath the head.
Clean the shrink disk.
Table 12-36
Lubricant
Molykote 321 R (lubricant paint)
Molykote spray (powder spray)
Molykote G Rapid
Molykombin UMFT 1
Unimily P5
Aemasol MO 19 P
12.3.16
SIMOLOC assembly system
12.3.16.1
General notes for the SIMOLOC assembly system
Risk of injury due to freely rotating parts
Fit a cover cap or protection cover.
NOTICE
Damaged components impair the correct function of the gearbox
If any components are damaged, the correct function of the gearbox will no longer be ensured.
Do not install any damaged gearbox components.
NOTICE
Lubricant on the machine shaft
Keep the bore in the tapered bushing
Do not use impure solvents and soiled cleaning cloths.
NOTICE
Avoid overloading the individual bolts
Do not exceed the maximum tightening torque for the tightening bolts
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
Lubricants for shrink disks
WARNING
Additional information on the SIMOGEAR geared motor
to grease the bolts, applying the paste to the thread and
2
Sold as
Spray
Spray or paste
Spray
Powder
Spray or paste
①
impairs the torque transmission
⑨
and the machine shaft
12.3 Specific data gearbox
Manufacturer
DOW Corning
Klüber Lubrication
A. C. Matthes
①
completely grease-free.
④
⑩
und
.
499