Conveyors; Conveyor, One Direction And One Speed (P3393 = 1) - Siemens SINAMICS G115D Operating Instructions Manual

Advanced commissioning
7.9 Conveyor technology control functions (for G115D PROFINET and AS-i variants only)
• Corner turntable lifts
• Travelling trolleys
Commission tool
It is recommended that you commission the conveyor control function using the Startdrive
PC tool or the SINAMICS G120 Smart Access.
Note
All screenshots in Chapter "Conveyor technology control functions" take the converter with
PROFINET interface by using the Startdrive PC tool as examples. You can also commission the
functions via the SINAMICS G120 Smart Access. For more information, see Section "Application
setup" in the SINAMICS G120 Smart Access Operating Instructions.
7.9.1

Conveyors

Conveyors move materials from one location to another. There are different types of conveyors
(for example, roller conveyors, chain conveyors, or belt conveyors) available for use according
to your particular applications.
7.9.1.1

Conveyor, one direction and one speed (p3393 = 1)

Overview
With p3393 (conveyor technology application) set to 1, the converter enables the load on a
conveyor belt to move in one direction with a fixed speed. A sensor is required to signal the limit
position for the motor to stop.
186
Commissioning tools (Page 106)
Overview of the manuals (Page 588)
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA