Commissioning Tools; Preparing For Commissioning; Factory Settings - Siemens SINAMICS G115D Operating Instructions Manual

Commissioning

5.2 Commissioning tools

5.2 Commissioning tools
PC tool - Startdrive V16.3
Startdrive is a PC tool that is used to commission, troubleshoot and control the drive, as well
as to back up and transfer the drive settings. You can connect the PC with the converter via a
USB cable or via the PROFINET fieldbus. The maximum permissible length of the USB cable is
3 m.
The SINAMICS G115D supports operation with Startdrive of version 16.3 or higher.
System requirements and download
Internet: Startdrive download
(https://support.industry.siemens.com/cs/ww/en/view/109771710)
Note
Commissioning and/or diagnostic failure resulting from unsafe mobile device or PC
Using unsafe mobile devices or PC to commission and/or diagnose the converter through
commissioning tools can cause system failure or unsafe operating status in your system.
• Maintain the mobile device or PC for commissioning and diagnostics according to the
security guidelines, for example, by deploying the patches for the operating system,
activating firewalls, or using a virus scanner.
Compliance with the General Data Protection Regulation
Siemens respects the principles of data protection, in particular the data minimization rules
(privacy by design).
For this product, it has the following meaning:
The product neither processes nor stores any person-related data. The product only processes
or stores technical function data (e.g. time stamps). If you link these data with other data
(e.g. shift plans) or store person-related data on the same data medium (e.g. hard disk), i.e,
personalizing the data, you must ensure full compliance with the applicable data protection
stipulations.
5.3

Preparing for commissioning

5.3.1

Factory settings

Motor
For the SINAMICS G115D Wall Mounted drive, the converter is pre-configured for an
asynchronous motor that matches the rated power of the converter.
For the SINAMICS G115D Motor Mounted drive, the converter has been set in the factory to
the delivery condition to match the provided 2KJ8 geared motor.
For more information about restoring settings to the delivery condition on the SINAMICS
G115D Motor Mounted drive, refer to the following section:
84
Restoring the factory settings/delivery condition (without safety functions) (Page 98)
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
SINAMICS G115D distributed drive