Starting The Commissioning Wizard; Carrying Out Quick Commissioning - Siemens SINAMICS G115D Operating Instructions Manual

Distributed drive for conveyor applications

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

Starting the Commissioning Wizard

1. Select your project and click on the

2. In the following screen form, select the converter with which you wish to go online.

3. Once you are online, select the following command from the project tree:

You have started the Commissioning Wizard of the converter.

Select motor control mode.

Select the I/O configuration to pre-assign the converter interfaces.

• Set the applicable motor standard and the converter supply voltage.

• Select the application for the drive:

– [0] Load cycle with high overload: for applications requiring a high dynamic performance,

– [1] Load cycle with low overload: for applications that do not require a high dynamic

• Set the pulse frequency for the converter.

If an external braking resistor is installed, you must set the maximum permissible braking

power of the braking resistor.

SINAMICS G115D Wall Mounted distributed drive

Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA

Motor control (Page 282)

Factory interface setting (Page 82)

e.g. conveyor systems.

performance, e.g. pumps or fans.

6.4 Quick commissioning

button to establish the online connection.

Commissioning