Electromechanical Potentiometer - Siemens SINAMICS G115D Operating Instructions Manual

Distributed drive for conveyor applications

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

p1075[0...n]

p1076[0...n]

r2050[0...11] CO: PROFIdrive PZD receive word

Further information

For further information refer to the function diagrams 2468, 9360 and 3030 of the List Manual.

Electromechanical potentiometer

The converter has two electromechanical potentiometers.

The potentiometers are hardwired with the internal analog inputs 0 and 1.

For more information on using a tool to adjust the two electromechanical potentiometers,

refer to the replacing procedure in Section "Replacing the Electronic Module (Page 394)".

SINAMICS G115D Wall Mounted distributed drive

Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA

CO: Main setpoint active

CI: Supplementary setpoint

CI: Supplementary setpoint scaling Signal source for scaling the supplementary set‐

CO: Supplementary setpoint effec‐

Advanced commissioning

Displays the active main setpoint.

Signal source for the supplementary setpoint.

Factory setting: 0

point. Factory setting: 0

Displays the effective supplementary setpoint.

Connector output to interconnect the PZD received

from the fieldbus controller in the word format.

[1] Most standard telegrams receive the speed set‐

point as receive word PZD02.

7.17 Setpoints