NetApp ASA C Series Install page 99

If you removed the media converters (QSFPs or SFPs), remember to reinstall them if you are using
fiber optic cables.
4. If the power supplies were unplugged, plug them back in and reinstall the power cable retainers.
5. Insert the controller module into the chassis:
a. Ensure the latching mechanism arms are locked in the fully extended position.
b. Using both hands, align and gently slide the controller module into the latching mechanism arms
until it stops.
c. Place your index fingers through the finger holes from the inside of the latching mechanism.
d. Press your thumbs down on the orange tabs on top of the latching mechanism and gently push
the controller module over the stop.
e. Release your thumbs from the top of the latching mechanisms and continue pushing until the
latching mechanisms snap into place.
The controller module begins to boot as soon as it is fully seated in the chassis. Be prepared to
interrupt the boot process.
f. Halt the controller at the LOADER prompt.
The controller module should be fully inserted and flush with the edges of the chassis.
6. Reset the time and date on the controller:
a. Check the date and time on the healthy controller with the
b. At the LOADER prompt on the target controller, check the time and date.
c. If necessary, modify the date with the
d. If necessary, set the time, in GMT, using the
e. Confirm the date and time on the target controller.
7. At the LOADER prompt, enter
controller reboot.
8. Return the controller to normal operation by giving back its storage:
-ofnode impaired_node_name
9. If automatic giveback was disabled, reenable it:
-auto-giveback true
== Step 5: Return the failed part to NetApp
Return the failed part to NetApp, as described in the RMA instructions shipped with the kit. See the
Return & Replacements
= ASA C400 systems
= Install and setup
= Start here: Choose your installation and setup experience
:icons: font
:relative_path: ./asa-c-400/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
set date mm/dd/yyyy
to reinitialize the PCIe cards and other components and let the
bye
page for further information.
show date
command.
set time hh:mm:ss
storage failover giveback
storage failover modify -node local
command.
command.
Part
97