NetApp ASA C Series Install page 169

interrupt the boot process.
d. If you have not already done so, reinstall the cable management device.
e. Interrupt the normal boot process and boot to LOADER by pressing Ctrl-C.
If your system stops at the boot menu, select the option to boot to LOADER.
f. At the LOADER prompt, enter
== Step 5: Restore the controller module to operation
You must recable the system, give back the controller module, and then reenable automatic giveback.
1. Recable the system, as needed.
If you removed the media converters (QSFPs or SFPs), remember to reinstall them if you are using
fiber optic cables.
2. Return the controller to normal operation by giving back its storage:
-ofnode impaired_node_name
3. If automatic giveback was disabled, reenable it:
-auto-giveback true
== Step 6: Switch back aggregates in a two-node MetroCluster configuration
After you have completed the FRU replacement in a two-node MetroCluster configuration, you can
perform the MetroCluster switchback operation. This returns the configuration to its normal operating
state, with the sync-source storage virtual machines (SVMs) on the formerly impaired site now active and
serving data from the local disk pools.
This task only applies to two-node MetroCluster configurations.
Steps
1. Verify that all nodes are in the
cluster_B::>
DR
Group Cluster Node
----- ------- -------------- -------------- ---------
--------------------
1 cluster_A
completed
cluster_B
switchback recovery
2 entries were displayed.
to reinitialize the PCIe cards and other components.
bye
state:
enabled
metrocluster node show
Configuration
State
controller_A_1 configured
controller_B_1 configured
storage failover giveback
storage failover modify -node local
metrocluster node show
DR
Mirroring Mode
enabled
enabled
heal roots
waiting for
167