NetApp ASA C Series Install page 239

◦ If your system has onboard keymanager, NSE or NVE configured, go to
NVE as needed
◦ If your system does not have onboard keymanager, NSE or NVE configured, complete the steps
in this section.
6. From the LOADER prompt, enter the
If you see...
The login prompt
Waiting for giveback...
7. Connect the console cable to the partner controller.
8. Give back the controller using the
9. At the cluster prompt, check the logical interfaces with the
If any interfaces are listed as "false", revert those interfaces back to their home port using the
command.
int revert
10. Move the console cable to the repaired controller and run the
ONTAP versions.
11. Restore automatic giveback if you disabled it by using the
local -auto-giveback true
= Restore OKM, NSE, and NVE as needed - ASA C800
:icons: font
:relative_path: ./asa-c-800/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
Once environment variables are checked, you must complete steps specific to
systems that have Onboard Key Manager (OKM), NetApp Storage Encryption (NSE)
or NetApp Volume Encryption (NVE) enabled.
Determine which section you should use to restore your OKM, NSE, or NVE configurations:
If NSE or NVE are enabled along with Onboard Key Manager you must restore settings you captured at
the beginning of this procedure.
• If NSE or NVE are enabled and Onboard Key Manager is enabled, go to
NSE when Onboard Key Manager is
• If NSE or NVE are enabled for ONATP 9.5, go to
ONTAP 9.5 and earlier].
• If NSE or NVE are enabled for ONTAP 9.6, go to
ONTAP 9.6 and later].
== Option 1: Restore NVE or NSE when Onboard Key Manager is enabled
command.
boot_ontap
Then...
Go to the next Step.
a. Log into the partner controller.
b. Confirm the target controller is ready for giveback with the
storage failover show
storage failover giveback -fromnode local
command.
enabled].
[Option 2: Restore NSE/NVE on systems running
[Option 3: Restore NSE/NVE on systems running
Restore OKM, NSE, and
command.
net int -is-home false
command to check the
version -v
storage failover modify -node
[Option 1: Restore NVE or
command
command.
net
237