NetApp ASA C Series Install page 261

2. Note the orientation of the NVDIMM in the socket so that you can insert the NVDIMM in the
replacement controller module in the proper orientation.
3. Eject the NVDIMM from its slot by slowly pushing apart the two NVDIMM ejector tabs on either side of
the NVDIMM, and then slide the NVDIMM out of the socket and set it aside.
Carefully hold the NVDIMM by the edges to avoid pressure on the components on the
NVDIMM circuit board.
4. Locate the slot where you are installing the NVDIMM.
5. Insert the NVDIMM squarely into the slot.
The NVDIMM fits tightly in the slot, but should go in easily. If not, realign the NVDIMM with the slot
and reinsert it.
Visually inspect the NVDIMM to verify that it is evenly aligned and fully inserted into the
slot.
6. Push carefully, but firmly, on the top edge of the NVDIMM until the ejector tabs snap into place over
the notches at the ends of the NVDIMM.
7. Repeat the preceding steps to move the other NVDIMM.
== Step 8: Move the boot media
You must move the boot media device from the impaired controller and install it in the replacement
controller.
The boot media is located under Riser 3.
1. Locate the boot media:
Air duct
NVDIMMs
259