NetApp ASA C Series Install page 37

9. Use the
storage encryption disk show
10. Use the
security key-manager key query
authentication keys that are stored on the key management servers.
◦ If the Restored
replacement process.
◦ If the
Key Manager type
yes/true, use the
key IDs of the authentication keys.
If the command fails, contact Customer Support.
◦ If the Key Manager type
yes/true, use the
Manager type.
Use the
security key-manager key query
for all authentication keys.
yes/true
11. Connect the console cable to the partner controller.
12. Give back the controller using the
13. Restore automatic giveback if you disabled it by using the
local -auto-giveback true
= Return the failed part to NetApp - ASA C250
:icons: font
:relative_path: ./asa-c-250/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
Return the failed part to NetApp, as described in the RMA instructions shipped with
the kit. See the Part Return & Replacements
= Chassis
= Overview of chassis replacement - ASA C250
:icons: font
:relative_path: ./asa-c-250/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
To replace the chassis, you must move the bezel, controller modules, and NVMe
drives from the impaired chassis to the replacement chassis, and then remove the
impaired chassis from the equipment rack or system cabinet and install the
replacement chassis in its place.
About this task
• All other components in the system must be functioning properly; if not, you must contact technical
support.
• You can use this procedure with all versions of ONTAP supported by your system.
• This procedure is written with the assumption that you are moving the bezel, NVMe drives, and
column = yes/true, you are done and can proceed to complete the
=
external
security key-manager external restore
= onboard and the
security key-manager onboard sync
storage failover giveback -fromnode local
command.
at the clustershell prompt, to review the output.
command to display the key IDs of the
and the column = anything other than
Restored
Restored column = anything other than
command to verify that the
storage failover modify -node
page for further information.
command to restore the
command to re-sync the Key
column =
Restored
command.
35