NetApp ASA C Series Install page 221

If the management network
has DHCP...
Not configured
4. Using System Manager on your laptop or console, configure your cluster:
a. Point your browser to the node management IP address.
The format for the address is https://x.x.x.x.
b. Configure the system using the data you collected in the
5. Verify the health of your system by running Config Advisor.
6. After you have completed the initial configuration, go to the
Documentation Resources
= Maintain
= Maintain ASA C800 hardware
:icons: font
:relative_path: ./asa-c-800/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
For the ASA C800 storage system, you can perform maintenance procedures on the
following components.
== Boot media
The boot media stores a primary and secondary set of boot image files that the system uses when it
boots.
== Chassis
The chassis is the physical enclosure housing all the controller components such as the controller/CPU
unit, power supply, and I/O.
== Controller
A controller consists of a board, firmware, and software. It controls the drives and implements the ONTAP
functions.
== DIMM
You must replace a DIMM (dual in-line memory module) when a memory mismatch is present, or you
have a failed DIMM.
Then...
a. Open a console session using PuTTY, a terminal server, or the
equivalent for your environment.
Check your laptop or console's online help if
you do not know how to configure PuTTY.
b. Enter the management IP address when prompted by the
script.
page for information about configuring additional features in ONTAP.
ONTAP Configuration
ONTAP & ONTAP System Manager
Guide.
219