NetApp ASA C Series Install page 124

Do not use excessive force when sliding the controller module into the chassis to
avoid damaging the connectors.
The controller module begins to boot as soon as it is fully seated in the chassis. Be prepared to
interrupt the boot process.
c. Rotate the locking latches upward, tilting them so that they clear the locking pins, and then lower
them into the locked position.
d. If you have not already done so, reinstall the cable management device.
8. Interrupt the boot process by pressing Ctrl-C to stop at the LOADER prompt.
If you miss this message, press Ctrl-C, select the option to boot to Maintenance mode, and then
the controller to boot to LOADER.
9. If the controller is in a stretch or fabric-attached MetroCluster, you must restore the FC adapter
configuration:
a. Boot to Maintenance mode:
b. Set the MetroCluster ports as initiators:
adapter_name
c. Halt to return to Maintenance mode:
The changes will be implemented when the system is booted.
= Boot the recovery image - ASA C400
:icons: font
:relative_path: ./asa-c-400/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
The procedure for booting the impaired controller from the recovery image depends
on whether the system is in a two-node MetroCluster configuration.
== Option 1: Most systems
You must boot the ONTAP image from the USB drive, restore the file system, and verify the
environmental variables.
This procedure applies to systems that are not in a two-node MetroCluster configuration.
Steps
1. From the LOADER prompt, boot the recovery image from the USB flash drive:
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3. Restore the
file system:
var
122
boot_ontap maint
ucadmin modify -m fc -t initiator
halt
halt
boot_recovery