NetApp ASA C Series Install page 30

◦ If your system does not have onboard keymanager, NSE or NVE configured, complete the steps in this
section.
6. From the LOADER prompt, enter the
If you see...
The login prompt
Waiting for giveback...
7. Connect the console cable to the partner controller.
8. Give back the controller using the
9. At the cluster prompt, check the logical interfaces with the
If any interfaces are listed as "false", revert those interfaces back to their home port using the
command.
revert
10. Move the console cable to the repaired controller and run the
versions.
11. Restore automatic giveback if you disabled it by using the
-auto-giveback true
28
boot_ontap
Then...
Go to the next Step.
a. Log into the partner controller.
b. Confirm the target controller is ready for giveback with the
storage failover show
storage failover giveback -fromnode local
command.
command.
command.
net int -is-home false
version -v
storage failover modify -node local
command.
command.
net int
command to check the ONTAP