NetApp ASA C Series Install page 12

Option 1: If network discovery is enabled
If you have network discovery enabled on your laptop, you can complete system setup and configuration
using automatic cluster discovery.
Steps
1. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
The system begins to boot. Initial booting may take up to eight minutes.
2. Make sure that your laptop has network discovery enabled.
See your laptop's online help for more information.
3. Use the animation to connect your laptop to the Management switch:
Animation - Connect your laptop to the Management switch
4. Select an ONTAP icon listed to discover:
a. Open File Explorer.
b. Click Network in the left pane.
c. Right-click and select refresh.
d. Double-click either ONTAP icon and accept any certificates displayed on your screen.
XXXXX is the system serial number for the target node.
System Manager opens.
5. Use System Manager guided setup to configure your system using the data you collected in the
ONTAP Configuration
6. Verify the health of your system by running Config Advisor.
7. After you have completed the initial configuration, go to the
10
Guide.
ONTAP & ONTAP System Manager