NetApp ASA C Series Install page 98

4. Visually inspect the battery to make sure that it is completely installed into the holder and that the
polarity is correct.
== Step 4: Reinstall the controller module and setting time/date after RTC battery replacement
After you replace a component within the controller module, you must reinstall the controller module in the
system chassis, reset the time and date on the controller, and then boot it.
1. If you have not already done so, close the air duct or controller module cover.
2. Align the end of the controller module with the opening in the chassis, and then gently push the
controller module halfway into the system.
Do not completely insert the controller module in the chassis until instructed to do so.
3. Recable the system, as needed.
96
With positive polarity face up, slide the battery
under the tab of the battery housing.
Push the battery gently into place and make sure
the tab secures it to the housing.
Pushing it in aggressively might
cause the battery to eject out
again.