NetApp ASA C Series Install page 155

== Step 2: Verify and set the HA state of the controller module
You must verify the state of the controller module and, if necessary, update the state to match your
HA
system configuration.
1. In Maintenance mode from the new controller module, verify that all components display the same
state:
ha-config show
The HA state should be the same for all components.
2. If the displayed system state of the controller module does not match your system configuration, set
the state for the controller module:
HA
The value for HA-state can be one of the following:
◦
ha
◦
mcc
◦
mcc-2n
◦
mccip
◦
non-ha
3. If the displayed system state of the controller module does not match your system configuration, set
the state for the controller module:
HA
4. Confirm that the setting has changed:
= Recable the system and reassign disks - ASA C400
:icons: font
:relative_path: ./asa-c-400/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
Continue the replacement procedure by recabling the storage and confirming disk
reassignment.
== Step 1: Recable the system
Recable the controller module's storage and network connections.
Steps
1. Recable the system.
2. Verify that the cabling is correct by using
a. Download and install Config Advisor.
b. Enter the information for the target system, and then click Collect Data.
c. Click the Cabling tab, and then examine the output. Make sure that all disk shelves are displayed
and all disks appear in the output, correcting any cabling issues you find.
d. Check other cabling by clicking the appropriate tab, and then examining the output from Config
Advisor.
== Step 2: Reassign disks
ha-config modify controller ha-state
ha-config modify controller ha-state
ha-config show
Active IQ Config Advisor.
HA
153