NetApp ASA C Series Install page 269

node1_siteA::> metrocluster node show -fields configuration-state
dr-group-id
-----------
-------------------
1 node1_siteA
1 node1_siteA
1 node1_siteB
1 node1_siteB
4 entries were displayed.
11. Verify that the expected volumes are present for each controller:
12. If you disabled automatic takeover on reboot, enable it from the healthy controller:
failover modify -node replacement-node-name -onreboot true
= Complete system restoration - ASA C800
:icons: font
:relative_path: ./asa-c-800/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
To restore your system to full operation, you must restore the NetApp Storage
Encryption configuration (if necessary), and install licenses for the new controller, and
return the failed part to NetApp, as described in the RMA instructions shipped with
the kit.
== Step 1: Install licenses for the replacement controller in ONTAP
You must install new licenses for the replacement node if the impaired node was using ONTAP features
that require a standard (node-locked) license. For features with standard licenses, each node in the
cluster should have its own key for the feature.
About this task
Until you install license keys, features requiring standard licenses continue to be available to the
replacement node. However, if the impaired node was the only node in the cluster with a license for the
feature, no configuration changes to the feature are allowed. Also, using unlicensed features on the node
might put you out of compliance with your license agreement, so you should install the replacement
license key or keys on the replacement node as soon as possible.
Before you begin
The licenses keys must be in the 28-character format.
You have a 90-day grace period in which to install the license keys. After the grace period, all old licenses
are invalidated. After a valid license key is installed, you have 24 hours to install all of the keys before the
grace period ends.
Steps
1. If you need new license keys, obtain replacement license keys on the
Support section under Software licenses.
cluster node
---------------------- --------------
node1mcc-001
node1mcc-002
node1mcc-003
node1mcc-004
configuration-state
configured
configured
configured
configured
vol show -node node-name
storage
NetApp Support Site in the My
267