NetApp ASA C Series Install page 31

You must boot the ONTAP image from the USB drive, restore the file system, and verify the
environmental variables.
1. From the LOADER prompt, boot the recovery image from the USB flash drive:
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3. Restore the
file system:
var
If your system has...
A network connection
No network connection
Then...
a. Press
when prompted to restore the backup configuration.
y
b. Set the healthy controller to advanced privilege level:
-privilege advanced
c. Run the restore backup command:
backup -node local -target-address
impaired_node_IP_address
d. Return the controller to admin level:
admin
e. Press
when prompted to use the restored configuration.
y
f. Press
when prompted to reboot the controller.
y
a. Press
when prompted to restore the backup configuration.
n
b. Reboot the system when prompted by the system.
c. Select the Update flash from backup config (sync flash)
option from the displayed menu.
If you are prompted to continue with the update, press y.
boot_recovery
set
system node restore-
set -privilege
29