NetApp ASA C Series Install page 159

Before you begin
The licenses keys must be in the 28-character format.
You have a 90-day grace period in which to install the license keys. After the grace period, all old licenses
are invalidated. After a valid license key is installed, you have 24 hours to install all of the keys before the
grace period ends.
Steps
1. If you need new license keys, obtain replacement license keys on the
Support section under Software licenses.
The new license keys that you require are automatically generated and sent to the
email address on file. If you fail to receive the email with the license keys within 30
days, you should contact technical support.
2. Install each license key:
key...
3. Remove the old licenses, if desired:
a. Check for unused licenses:
b. If the list looks correct, remove the unused licenses:
== Step 2: Verify LIFs and registering the serial number
Before returning the replacement node to service, you should verify that the LIFs are on their home ports,
and register the serial number of the replacement node if AutoSupport is enabled, and reset automatic
giveback.
Steps
1. Verify that the logical interfaces are reporting to their home server and ports:
show -is-home false
If any LIFs are listed as false, revert them to their home ports:
-vserver * -lif *
2. Register the system serial number with NetApp Support.
◦ If AutoSupport is enabled, send an AutoSupport message to register the serial number.
◦ If AutoSupport is not enabled, call
3. If an AutoSupport maintenance window was triggered, end it by using the
autosupport invoke -node * -type all -message MAINT=END
4. If automatic giveback was disabled, reenable it:
-auto-giveback true
== Step 3: Switch back aggregates in a two-node MetroCluster configuration
After you have completed the FRU replacement in a two-node MetroCluster configuration, you can
perform the MetroCluster switchback operation. This returns the configuration to its normal operating
state, with the sync-source storage virtual machines (SVMs) on the formerly impaired site now active and
serving data from the local disk pools.
system license add -license-code license-key, license-
license clean-up -unused -simulate
NetApp Support
NetApp Support Site
license clean-up -unused
network interface revert
to register the serial number.
storage failover modify -node local
in the My
network interface
system node
command.
157