NetApp ASA C Series Install page 170

2. Verify that resynchronization is complete on all SVMs:
3. Verify that any automatic LIF migrations being performed by the healing operations were completed
successfully:
metrocluster check lif show
4. Perform the switchback by using the
surviving cluster.
5. Verify that the switchback operation has completed:
The switchback operation is still running when a cluster is in the
cluster_B::> metrocluster show
Cluster
--------------------
Local: cluster_B configured
Remote: cluster_A configured
The switchback operation is complete when the clusters are in the
cluster_B::> metrocluster show
Cluster
--------------------
Local: cluster_B configured
Remote: cluster_A configured
If a switchback is taking a long time to finish, you can check on the status of in-progress baselines by
using the metrocluster config-replication resync-status show
6. Reestablish any SnapMirror or SnapVault configurations.
== Step 7: Return the failed part to NetApp
Return the failed part to NetApp, as described in the RMA instructions shipped with the kit. See the
Return & Replacements
= Hot-swap a fan module - ASA C400
:icons: font
:relative_path: ./asa-c-400/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
To swap out a fan module without interrupting service, you must perform a specific
sequence of tasks.
You must replace the fan module within two minutes of removing it from the chassis.
System airflow is disrupted and the controller module or modules shut down after two
minutes to avoid overheating.
You can use the following animation, illustration, or the written steps to hot-swap a fan module.
168
metrocluster switchback
Configuration State
-------------------
Configuration State
-------------------
page for further information.
metrocluster vserver show
command from any node in the
metrocluster show
waiting-for-switchback
Mode
---------
switchover
waiting-for-switchback
normal state.:
Mode
---------
normal
normal
state:
command.
Part