NetApp ASA C Series Install page 130

synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the
process. See the appropriate Documentation Center for more information.
11. Once the giveback completes, check the failover and giveback status with the
and
show `storage failover
Only the CFO aggregates (root aggregate and CFO style data aggregates) will be shown.
12. Move the console cable to the target controller.
a. If you are running ONTAP 9.6 or later, run the security key-manager onboard sync:
b. Run the
security key-manager onboard sync
when prompted.
c. Enter the
security key-manager key query
stored in the onboard key manager and verify that the
authentication keys.
If the
Support.
d. Wait 10 minutes for the key to synchronize across the cluster.
13. Move the console cable to the partner controller.
14. Give back the target controller using the
command.
15. Check the giveback status, 3 minutes after it reports complete, using the
command.
If giveback is not complete after 20 minutes, contact Customer Support.
16. At the clustershell prompt, enter the
interfaces that are not on their home controller and port.
If any interfaces are listed as false, revert those interfaces back to their home port using the
int revert -vserver Cluster -lif nodename
17. Move the console cable to the target controller and run the
ONTAP versions.
18. Restore automatic giveback if you disabled it by using the
local -auto-giveback true
== Restore NSE/NVE on systems running ONTAP 9.6 and later
Steps
1. Connect the console cable to the target controller.
2. Use the
boot_ontap
3. Check the console output:
If the console displays...
128
show-giveback` commands.
column = anything other than yes/true, contact Customer
Restored
storage failover giveback -fromnode local
net int show -is-home false
command.
command at the LOADER prompt to boot the controller.
command and then enter the passphrase
command to see a detailed view of all keys
column =
Restored
storage failover show
command to list the logical
command.
command to check the
version -v
storage failover modify -node
Then...
storage failover
for all
yes/true
net