NetApp ASA C Series Install page 108

behind the faceplate.
Animation - Set drive shelf IDs
2. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
3. Make sure that your laptop has network discovery enabled.
See your laptop's online help for more information.
4. Connect your laptop to the Management switch.
1. Select an ONTAP icon listed to discover:
a. Open File Explorer.
b. Click network in the left pane.
c. Right click and select refresh.
d. Double-click either ONTAP icon and accept any certificates displayed on your screen.
XXXXX is the system serial number for the target node.
System Manager opens.
2. Use System Manager guided setup to configure your system using the data you collected in the
NetApp ONTAP Configuration Guide.
ONTAP Configuration Guide
106