Download Print this page

NetApp ASA C Series Install page 35

Advertisement

The system boots to Waiting for giveback... prompt.
8. Move the console cable to the partner controller and login as "admin".
9. Confirm the target controller is ready for giveback with the
10. Giveback only the CFO aggregates with the
-only-cfo-aggregates true
◦ If the command fails because of a failed disk, physically disengage the failed disk, but leave the
disk in the slot until a replacement is received.
◦ If the command fails because of an open CIFS sessions, check with customer how to close out
CIFS sessions.
Terminating CIFS can cause loss of data.
◦ If the command fails because the partner "not ready", wait 5 minutes for the NVMEMs to
synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the
process. See the appropriate Documentation Center for more information.
11. Once the giveback completes, check the failover and giveback status with the
and
show
`storage failover
Only the CFO aggregates (root aggregate and CFO style data aggregates) will be shown.
12. Move the console cable to the target controller.
a. If you are running ONTAP 9.6 or later, run the security key-manager onboard sync:
b. Run the
security key-manager onboard sync
when prompted.
c. Enter the
security key-manager key query
stored in the onboard key manager and verify that the
authentication keys.
If the
Support.
d. Wait 10 minutes for the key to synchronize across the cluster.
13. Move the console cable to the partner controller.
14. Give back the target controller using the
command.
15. Check the giveback status, 3 minutes after it reports complete, using the
command.
If giveback is not complete after 20 minutes, contact Customer Support.
16. At the clustershell prompt, enter the
interfaces that are not on their home controller and port.
If any interfaces are listed as false, revert those interfaces back to their home port using the
int revert -vserver Cluster -lif nodename
storage failover giveback -fromnode local
command.
show-giveback` commands.
column = anything other than yes/true, contact Customer
Restored
storage failover giveback -fromnode local
net int show -is-home false
storage failover show
storage failover
command and then enter the passphrase
command to see a detailed view of all keys
column =
Restored
storage failover show
command to list the logical
command.
command.
for all
yes/true
net
33

Advertisement

loading
Need help?

Need help?

Do you have a question about the ASA C Series and is the answer not in the manual?

Subscribe to Our Youtube Channel