NetApp ASA C Series Install page 189

cluster_B::>
DR
Group Cluster Node
----- ------- -------------- -------------- ---------
--------------------
1 cluster_A
completed
cluster_B
switchback recovery
2 entries were displayed.
2. Verify that resynchronization is complete on all SVMs:
3. Verify that any automatic LIF migrations being performed by the healing operations were completed
successfully:
metrocluster check lif show
4. Perform the switchback by using the
surviving cluster.
5. Verify that the switchback operation has completed:
The switchback operation is still running when a cluster is in the
cluster_B::> metrocluster show
Cluster
--------------------
Local: cluster_B configured
Remote: cluster_A configured
The switchback operation is complete when the clusters are in the
cluster_B::> metrocluster show
Cluster
--------------------
Local: cluster_B configured
Remote: cluster_A configured
If a switchback is taking a long time to finish, you can check on the status of in-progress baselines by
using the
metrocluster config-replication resync-status show
6. Reestablish any SnapMirror or SnapVault configurations.
== Step 7: Return the failed part to NetApp
metrocluster node show
Configuration
State
controller_A_1 configured
controller_B_1 configured
metrocluster switchback
Configuration State
-------------------
Configuration State
-------------------
DR
Mirroring Mode
enabled
enabled
metrocluster vserver show
command from any node in the
metrocluster show
waiting-for-switchback
Mode
---------
switchover
waiting-for-switchback
state.:
normal
Mode
---------
normal
normal
heal roots
waiting for
state:
command.
187