NetApp ASA C Series Install page 118

the "Return a FIPS drive or SED to unprotected mode" section of
the CLI.
• You must leave the power supplies turned on at the end of this procedure to provide power to the
healthy controller.
Steps
1. Check the MetroCluster status to determine whether the impaired controller has automatically
switched over to the healthy controller:
2. Depending on whether an automatic switchover has occurred, proceed according to the following
table:
If the impaired controller...
Has automatically switched over Proceed to the next step.
Has not automatically switched
over
Has not automatically switched
over, you attempted switchover
with the
metrocluster
command, and
switchover
the switchover was vetoed
3. Resynchronize the data aggregates by running the
command from the surviving cluster.
controller_A_1::> metrocluster heal -phase aggregates
[Job 130] Job succeeded: Heal Aggregates is successful.
If the healing is vetoed, you have the option of reissuing the
the -override-vetoes
vetoes that prevent the healing operation.
4. Verify that the operation has been completed by using the metrocluster operation show command.
controller_A_1::> metrocluster operation show
Operation: heal-aggregates
State: successful
Start Time: 7/25/2016 18:45:55
End Time: 7/25/2016 18:45:56
Errors: -
5. Check the state of the aggregates by using the
116
metrocluster show
Then...
Perform a planned switchover operation from the healthy
controller:
metrocluster switchover
Review the veto messages and, if possible, resolve the issue and
try again. If you are unable to resolve the issue, contact technical
support.
parameter. If you use this optional parameter, the system overrides any soft
storage aggregate show
NetApp Encryption overview with
metrocluster heal -phase aggregates
metrocluster heal
command with
command.