▪
dns_addr
▪
dns_domain
If you use this optional parameter, you do not need a fully qualified domain name in the netboot
server URL. You need only the server's host name.
Other parameters might be necessary for your interface. You can enter
the firmware prompt for details.
Boot the recovery image - ASA C250
You must boot the ONTAP image from the USB drive, restore the file system, and verify
the environmental variables.
1. From the LOADER prompt, boot the recovery image from the USB flash drive:
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3. Restore the
file system:
var
If your system has...
A network connection
No network connection
26
is the IP address of a name server on your network.
is the Domain Name System (DNS) domain name.
Then...
a. Press
b. Set the healthy controller to advanced privilege level:
-privilege advanced
c. Run the restore backup command:
backup -node local -target-address
impaired_node_IP_address
d. Return the controller to admin level:
e. Press
f. Press
a. Press
b. Reboot the system when prompted by the system.
c. Select the Update flash from backup config (sync flash) option
from the displayed menu.
If you are prompted to continue with the update, press y.
y
when prompted to restore the backup configuration.
when prompted to use the restored configuration.
y
when prompted to reboot the controller.
y
when prompted to restore the backup configuration.
n
help ifconfig
boot_recovery
set
system node restore-
set -privilege admin
at
Need help?
Do you have a question about the ASA C Series and is the answer not in the manual?