NetApp ASA C Series Install page 260

controller module in the proper orientation.
2. Eject the DIMM from its slot by slowly pushing apart the two DIMM ejector tabs on either side of the
DIMM, and then slide the DIMM out of the slot.
Carefully hold the DIMM by the edges to avoid pressure on the components on the
DIMM circuit board.
3. Locate the slot where you are installing the DIMM.
4. Insert the DIMM squarely into the slot.
The DIMM fits tightly in the slot, but should go in easily. If not, realign the DIMM with the slot and
reinsert it.
Visually inspect the DIMM to verify that it is evenly aligned and fully inserted into the
slot.
5. Push carefully, but firmly, on the top edge of the DIMM until the ejector tabs snap into place over the
notches at the ends of the DIMM.
6. Repeat these steps for the remaining DIMMs.
== Step 7: Move the NVDIMMs
To move the NVDIMMs, locate and move them from the impaired controller into the replacement
controller and follow the specific sequence of steps.
1. Locate the NVDIMMs on your controller module.
258