Check Panel - Bentel Security KYO 320 Installation Manual

Check Panel

The Check option from the menu bar of KYO320 down-
loading software application
tions: Check Panel and Check Configuration.
Check Panel This option will allow you to view the
real-time status of the Control panel (see Fig. 55).
Entry of a valid User code PIN will allow you to control
the Zones, Outputs and Partitions and view the Timers
and Trouble windows.
To operate on a specific Partition: click on the Parti-
tion concerned then right-click to open a menu (see Fig.
55) which will allow you to:
D: Disarm; A: Arm Away mode; S: Arm Stay Mode; I: In-
stant (Arm Stay 0 Delay Mode) or Reset the Partition
concerned and Control panel.
To operate on a ALL Partitions: right-click on the Parti-
tion section to open a menu which will allow you to:
D: Disarm ALL Partitions; A: Arm ALL Partitions in Away
mode; S: Arm ALL Partitions in Stay mode; I: Arm ALL
Partitions in Instant mode (Stay 0 Delay) or Reset ALL
Partitions and Control panel.
To operate on a specific Zone:
right click on the Partition the
Zone belongs to, then right-click
to open a menu which will allow
you to: Bypass; Unbypass or
view the real-time analogue
value of the Zone. To control an
Output: right-click on the Output con-
cerned to open a menu which will al-
low you to turn the Output ON or
OFF.
About the function buttons (under User PIN field).
Clicking on the first button will open a menu
which will allow you to disable display of
real-time status data (enabled at default) re-
garding the Zones, Partitions, Trouble, Outputs
and Timers.
Clicking on the second
menu with the following options: Show violated
zones only; Audible signalling (Beep); Clear
manually.
Clicking on the third button will allow you to en-
able "Test" mode on ALL Zones.
Clicking on the fourth button will allow you to
disable "Test" mode on ALL Zones.
Clicking on the fifth button will allow you to Re-
set "Programming from PC" Trouble.
Clicking on the sixth button will close the win-
dow.
KYO 320
provides two sub-op-
Figure 54 Check panel Window
button will open a
Figure 55 Check Configuration Window
PROGRAMMING FROM THE PC
Check Configuration This option will allow you to
view the status of the Control panel peripherals in either
Test mode or Graphic mode (see Fig.56).
Graphic mode: The real-time status of each peripheral
will be indicated by the colour of its icon, as follows:
r Green: the peripheral concerned is in the configura-
tion and operating properly.
r Red: the peripheral concerned is in the configuration
but is in Tamper status (e.g. Frontplate open).
r Yellow: the peripheral concerned is in the configura-
tion but is missing.
r Orange: the peripheral concerned is in the configu-
ration but has the same address as another periph-
eral of the
peripheral-Possible tamper).
r White: the peripheral concerned is not included in
the configuration.
+
In Test mode the real-time status of each peripher-
als will be indicated by the colour of the virtual LED
located next to it.
same type (Duplicated
87