User Codes - Bentel Security KYO 320 Installation Manual

+
You cannot assign default PINs (refer to Table 10
on page 38).
If you attempt to assign a default PIN, the display will
show the following message:
Repeat new PIN
Invalid code!
+
You cannot assign a PIN which already exists on
the system.
+
Installer PIN allowed, for the 4-digit PINs: from
0201 to 9999 (0200 not usable), for the 5-digit PINs
from 00001 to 99999, for the 6-digit PINs from
000001 to 999999.
If you attempt to assign a duplicate PIN, the display will
show the following message:
Repeat new PIN
Duplicated PIN!
This message means that another User is using the PIN
concerned, therefore, the Control panel will consider
the Code to be "Uncovered" and, for security reasons,
will automatically restore the default PIN of the Code
concerned. If a User attempts to access the system
using an "Uncovered" PIN the display will show the fol-
lowing message:
17:05 26/08/2006
Uncovered PIN!
+
"Uncovered" PINs must be reprogrammed (refer to
Table 10 on page 38).
"Uncovered" PINs will be signalled by:
Ø the G LED (ON) on the Keypad
Ø the Uncovered PIN! message in View Trouble
mode
Øthe Event details in the Logger
TYPE = Uncovered PIN
IDENT. = the Keypad used
TIME = Time and Date of the Event
The Trouble status will clear as soon as a New PIN (other
than the default PIN) is assigned to the "Uncovered" Code.

User codes

The Installer code can:
Ø enable (make Active) the necessary number of User
codes (maximum 195)
Ø enable the User codes on specific Partitions
Ø define the A, B, C and D Arming modes of each User
code
Ø define the Father codes of each User code (for Co-
des 1 to 131 only)
Ø define the access level of each User code (refer to
"Control Panel Programming")
A Father code can enable/disable the Active status
of its Son codes and change their PINs.
KYO320
Ø For full details on User Code programming, refer to
"Code Type" under "Control Panel Programming".
To program the User code parameters, carefully work
through the following steps. From the Installer menu:
INSTALLER MENU
Event logger
1. Using A or B, select the User codes option.
INSTALLER MENU
User codes
2. Press ENTER.
Code
Code
3. Using A or B,select the required Code, or enter the
Code ID number. To go back to the INSTALLER MENU,
press ESC.
Code
Code
4. Press ENTER
Description
Code
5. Enter the Code Description (refer to "Editing a text"
under "Using the Keypad"), then press ENTER.
Code Type n. 001
User
6. Using A or B, select the required User Type then Press E.
16 User Types are available (in the example the User Type is
001). You can program the description of the User Type via the
"Code Type" option from the "Control Panel Programming"
menu.
Max Num. access
Always
7. Enter the maximum number of times the User Code
concerned will be allowed to access the system (refer to
"User Menu Access") or, using 0 select the Always
option to allow unlimited use. Press ENTER to confirm
and go to the next step.
Ass.timer n. ---
None
8. Using A or B, select the required Timer (refer
to "Associated Timer"), or enter its ID Number. If you do
not require a Timer, using 0 select the None option.
Press ENTER to confirm and go to the next step.
Partition
XXXXXXXX
KEYPAD OPERATIONS
n. 001
001
n. 002
002
002
type 001
1_8
11