Answering Machine; Voice Messages; Teleservice; Num.teleservice - Bentel Security KYO 320 Installation Manual

Event code
Code
9h. Enter the Event code (refer to "Code") of the action
being programmed, (This is not valid for Contact ID,
SIA and SIA over K-NET protocols) then press ENTER
to go back to step 5h.
Dig.com. setting
Attempts
Number 03
5j. Enter number of times (refer to "Attempts") the Con-
trol panel must dial a telephone before aborting a call,
then press ENTER.
Voice duration
Sec. 030
6j. Enter the maximum time allowed for the "2-way au-
dio" session (refer to "2-way audio"), then press ENTER
and go back to step 4c.
n Answering Machine
Message ---
Nothing
4k. Using A or B, select the Voice message for the
Answering machine facility, then press ENTER.
Repetition n.
Number 003
5k. Enter the number of times the Control panel must
play the Answering machine message (refer to "Messa-
ge repetitions"), then press ENTER.
Replay Pause
Sec. 005
6k. Enter the pause (in seconds) between the message
replays (refer to "Replay pause"), then press ENTER.
PIN timeout
Sec. 030
7k. Enter the maximum time the system will wait for a
valid PIN (entered on the remote telephone keypad) for
access to the system over the phone (refer to "PIN time-
out"), then press ENTER.
DTMF timeout
Sec. 030
8k. Enter the maximum time the system will wait for the
user to press a telephone key before it ends the call (re-
fer to "DTMF Tone Timeout"), then press ENTER to go
back to step 3.
KYO320

Voice messages

1.Using A or B, select the Vocal messages option.
PROGRAMMING
Vocal messages
2. Press ENTER:
Message
Message
3. Using A or B, select the Voice message to be pro-
grammed or enter the Voice message ID number, then
press ENTER, or press ESC to go back to step 1.
Description
Message
4. Enter the message text (refer to "Entering a text" un-
der "Using the Keypad"), then press ENTER.
Quality
Good
5. Using A or B, select the required message Quality
(Poor, Average, Good or Excellent), then press
ENTER.
Length
Sec.
+
NOTE: The selected quality will not be provided, if
the Leftover time is insufficient.
6. Enter the Message Length (refer to "Time"). The
Leftover time will be shown in brackets on the top line.
Press ENTER to go back to step 3.
PROGRAMMING
Configuration
+
The Quality and the Length of messages will be set
for number messagges 63 and 64 only.

Teleservice

1. From the PROGRAMMING menu, using A or B, se-
lect the Teleservice option.
PROGRAMMING
Teleservice
2. Press ENTER:
Teleservice

Num.teleservice

3. Using A or B, select: Num. teleservice, Teleservice
param., Teleservice option, Init teleservice, Mainte-
PROGRAM PANEL
n. 001
001
001
(000)
002
35