K3/Prt2 Printer Interface; Identification Of Parts; Connecting The Printer; Installation Instructions - Bentel Security KYO 320 Installation Manual

K3/PRT2 Printer Interface

!
Disconnect the Mains and battery power before
starting the installation procedure.
The optional K3/PRT2 Printer Interface will allow you to
connect the Control panel to a parallel printer for:
— Real-time printout of events (refer to "Accessories"
under "Configuration" in the Programming" section);
— Entire Log printout (refer to "Print Log" under "Key-
pad Codes – User" in the Programming" section and/or
"Event Log" under "Operating your system from a Key-
pad" in the USER MANUAL);
— Specific events printout (refer to " Log — Events Se-
tup" under "Programming" in the Installation Manual
Vol.1).
n Identification of Parts
The following Table describes the parts illustrated in Fi-
gure 5. The numbers in boldface in this section, refer to
parts in Figure 5 (unless otherwise specified).
No. DESCRIPTION
116 Interface connector
117 Printer connector
1 2 3 4
18 wire cable + shield: the shield must be soldered to the metal casing of both connectors
1 2 3 4
Table 11 Wiring diagram of the cable between the parallel printer and the Printer Interface
116
Figure 5 Printer Interface components
42
Interface connector: DB25 connector, male
5 6 7 8 9
5 6 7 8 9
Printer side: Centronics connector, 36 pin, male
117
n Connecting the Printer
If you prefer to chase the lead, use a plug-free cable (re-
fer to Table 11 for the wiring specifications and see also
Figure 6). Moulded plug leads (usually supplied with the
printer) cannot be chased.
n Installation instructions
Work carefully through the following steps (see Figure 5
and Figure 6).
1. Lay the cable between the printer and the Control
panel.
2. Plug the Printer interface into the connector 15 on
the Control panel PCB (see the paragraph "Identifi-
cation of parts" in the Installation Manual, Vol.1)
then, using the screws, secure it in place.
3. Connect the Printer lead to the connector 117 on
the Printer Interface.
10 11 12 13 14
10 11 12 13 14
Printer side:
36 18
Centronics connector, male:
35 17 pins from 15 to 17 and 19 through 30
must be connected together
34 16
and to pin 19 of the DB25 connector
33 15
32 14
31 13
30 12
29 11
28 10
27 9
26 8
25 7
24 6
23 5
22 4
21 3
20 2
19
1
Figure 6 Wiring diagram of parallel printer cable
15 16 17
32 31 36 15÷17/19÷30
Interface side:
connector
18 wire shielded cable
(max. length 10 m) :
the shield must be soldered
to the metallic casing
of both connectors
19
DB25
male
13
25
12
24
11
23
10
22
9
21
8
20
7
19
6
18
5
17
4
16
3
15
2
14
1
KYO320