Parts; The Panel - Bentel Security Omnia 8/L Manual

The table below provides a brief description of each part (the numbers in
boldface refer to the parts illustrated in the figure 1), and the meaning of
the ON / OFF status of each indicator LED.

The Panel

PARTS

1 4 screws
2 5 indicator LEDs
3 4 holes (Ø 5 mm)
4 NormVox2 voice board connector
5 Protection fuse for sensor and auxiliary power supply (250 V - 5 A)
6 Protection fuse against polarity inversion on battery (250 V - 8 A)
7 DB9 connector for PC connection via serial cable
8-8a Tamper microswitch-8a (Optional)
Connector for the 3 A switching power supply BAQ35 or BAW35
9
(optional)
10 Cable hole
11 Mains connection terminals (230 V~ ∋10% / 150 mA)
12 Housing for 13.8 V / 7 Ah standby battery (optional)
Service mode jumper. Connection of this jumper will disable the Alarm
13
outputs for maintenance purposes.
14 Battery connectors
15 Firmware Release: to be communicated to Service dealer
16 NCDUEVOX voice board (optional)
LEDs
ON:
OFF:
OFF:
ON:
OFF:
ON:
OFF:
ON:
OFF:
ON:
PARTS
DESCRIPTIONS
Panel powered by mains
Mains failure ----Panel powered by battery
Battery OK
Battery low or battery trouble
Fuse 5 intact (power to sensors)
Fuse 5 blown
Communicator in standby status: telephone line free
Telephone line engaged by the communicator
Communication OK
Communication bus trouble
STATUS
PARTS
5