Default Pins (Factory Default) - Bentel Security KYO 320 Installation Manual

5
1. Press to access Arm/Disarm Single Partitions.
1 0
2. Press to Arm, or
3. Enter the Identifier number of the Partition.
The Partition will turn Arm/Disarm immediately, and the
system will go back to step 1.
6
Enable/Disable Teleservice
This command will allow you to Enable/Disable the Te-
leservice facility
This is a toggle command:
Ø if Teleservice is ENABLED, it will be DISABLED: the
executed command will be confirmed by an audible
feed back signal (low-pitched sound);
Øif Teleservice is DISABLED, it will be ENABLED: the
executed command will be confirmed by an audible
feed back signal (high-pitched sound).
7
Record/Play Memo (With K3/VOX2 only)
This command will allow you to Record/Play a memo:
4
ØPress
to access the Record/Play Memo phase:
1
Ø Press
to record the message.
0
Ø Press
to play message.
The end of recording/playback will be signalled by an
audible feed back signal (buzz). If you enter a wrong
Code, or a message has already been recorded but not
played back, the system will emit an audible feedback
signal.
8
Reset Alarms
This command will allow you to clear Partition and/or
Control panel Alarms restore the system to standby, de-
pending on the Access level of the Code used via Te-
lephone.
9
Enable/Disable Current User Code (ACTIVE)
This command will allow you to select/deselect the
ACTIVE attribute for the entered User Code.
This is a toggle command:
Ø if the entered User Code is already ACTIVE, it will
become NOT ACTIVE (Disabled): the executed
command will be confirmed by an audible feed back
signal (low-pitched sound);
Ø if the entered User Code is NOT ACTIVE (Disabled),
it will become ACTIVE (Enabled): the executed com-
mand will be confirmed by an audible feed back si-
gnal (high-pitched sound).
to Disarm the Partition.
+
This security feature will allow you to protect your
system against unauthorized access. If you Disa-
ble a User Code via Telephone it cannot be used
again until it is Re-enabled via the User menu (refer
to "Programming PIN Codes" under "Accessing the
User Menu").

Default PINs (Factory default)

Table 7, on the following page, shows the default PINs
of the User Codes for KYO 320:
Ø the No. column shows the ID number of the User
Code;
Ø the Description. column (to be filled in by the Instal-
ler) is for the Code User's name;
Ø the PIN. column shows the default PIN of the corre-
sponding User Code. The default PIN will be resto-
red if the secret
Code PIN is duplicated (Disclosed) at random (refer to
"Programming PIN Codes" in the "OPERATING YOUR
SYSTEM FROM A KEYPAD" section).