Installing; Mounting The Main Unit; Connecting Keypads - Bentel Security KYO 320 Installation Manual

Mounting the Main Unit

Please read this section carefully to get an overall view of
the steps involved in installing the KYO320 Main Unit. The
KYO320 Main Unit should be located in a safe, dry place
that is far from sources of interference.
Once you have selected a suitable place, create a lay-
out of all the system peripherals (Keypads, Readers,
Detectors, etc.) and ensure that you will be able to con-
nect the Main power, peripherals, and if necessary, the
telephone line to the KYO320 without difficulty. Allow at
least 5 cm of free space around the Main Unit for air
flow.
!
The Main Unit must be at least 2 metres from
GSM and radio relay systems.
Work carefully through the following steps (see Figure
on page 10).
1. Remove the screws 1 and frontplate.
2. Install add-on modules and boards (K3/VOX2,
etc.), refer to the respective paragraphs for instruc-
tions.
3. Drill the holes for the cabinet and Seize microswitch
bracket anchor screws (5 and 13 respectively).
4. Pull the connection wires through the wire entry 11
then attach the cabinet and Seize microswitch
bracket to the wall.
+
DO NOT over tighten the screws as this may dam-
age the Seize microswitch bracket.
5. Complete the connections — DO NOT connect the
MAINS until all other wiring has been completed.
6. Connect the Mains Power (refer to "Connecting the
Mains Power").
7. Program the
"PROGRAMMING"
"PROGRAMMING FROM KEYPAD" Guide for in-
structions).
KYO 320
system (refer to
section and
n Connecting Keypads
Keypads should be located in places where full control
of the system is required: PREMIUM LCD, CLASSIKA
LCD, Keypads can be surface mounted on Mod. 503,
outlet boxes or similar.
PREMIUM keypad can be mounted on a suitable box
(accessory item) see Premium keypad manual.
+
Keypads should be mounted at eye level for easy
viewing.
Work carefully through the following steps (see Figure 5
on page 12) and/or respective manuals.
CAUTION - Before removing the CLASSIKA keypad
cover, open the down flip (67) COMPLETELY.
1. If the Keypads are closed, insert a little flat screw-
driver in the slot 79 (see Figure 4) and rotate in the
direction of the arrow. Open the keypad slightly
(see the position of the hands, Fig 4, 5); one part
will be composed of the cover with the mounted
PCB and on the other hand, the backplate with the
terminal board.
2. If you are surface mounting the Keypad: drill the
holes for the backplate anchor screws 76 (74), and
if required, for the seize microswitch bracket screw
82.
3. If you are surface mounting the Keypad on a suit-
able box: drill the holes for the seize microswitch
bracket screw 82.
4. Fix the keypad base in place.
5. Run the connection cables through opening 70.
6. Connect the wires to the terminal board 72.
7. Replace the keypad cover, before using the hooks 65
then block it with a slight pressure till the snaps 78
are clicked.
the
the

INSTALLING

INSTALLING
15