Output Test; Clear Call Queue; Voice Functions (K3/Vox2 Only); Recording - Bentel Security KYO 320 Installation Manual

Output test

This option will allow you to test the system Outputs.
From the Installer menu:
INSTALLER MENU
Event logger
1.Using A or B, select the Outputs test option.
INSTALLER MENU
outputs test
2. Press ENTER, a description of the first Control panel
Output will be shown.
Output n. 001
Burglar Siren
3.Using A or B, select the required Output.
4.Press ENTER, then ON or OFF, respectively, to acti-
vate/stop the selected Output.
Burglar Siren
INACTIVE
5.Press ESC to go back to the Installer menu.

Clear call queue

The option will allow you to clear all the telephone calls
in the outgoing Call queue.
From the Installer menu:
INSTALLER MENU
Event logger
1.Using A or B, select the Clear call queue option, then
press ENTER.
CLEAR CALL QUEVE
Confirm?
2. Press ENTER again, the Call Queue will clear, and the
system will go back to the Installer menu.
CLEAR CALL QUEVE
done!

Voice functions (K3/VOX2 only)

These functions are provided by the K3/VOX2 Voice
Board (accessory item). If the system is not equipped
with a K3/VOX2 board, the Voice functions option will
not be shown on the Installer menu.The K3/VOX2 Voi-
ce Board will allow the system to manage up to 64 voice
messages — all with programmable quality and dura-
tion. The total message time depends on sound quality,
and ranges from approximately 3 minutes 48 seconds
— for good sound quality, to approximately 8 minutes
KYO320
44 seconds — for average sound quality. The recorded
messages can be associated with the Control panel
Inputs for Telephone access, or sent to preset telepho-
ne numbers (Dialler function), or used as Answer mes-
sages (Answering machine function).
From the Installer menu:
INSTALLER MENU
Event logger
1.Using A or B, select the Voice functions option, then
press ENTER.
VOICE FUNCTIONS
Record message
2.Using A or B, select the Record message, Play
message or Delete messages option.
VOICE FUNCTIONS
Play message
n Recording
To record a voice message:
VOICE FUNCTIONS
Record message
3.Press ENTER.
REC MESSAGE 01
Message
4.Using A or B , select the message.
REC MESSAGE 02
Message
The Message description (maximum 16 characters) will
be shown on the second line of the display.
This description can be edited via PC or keypad by ac-
cessing the "Keypad Programming" section on the
Installer menu.
5.Press ENTER.
Quality
Excellent
6. Using A or B, select the recording quality: Excellent,
Good, Average and poor and press ENTER:
Seconds
Start record.
The message length (the example shows 180 seconds)
depend on selected message quality.
7. Press ENTER to start the recording phase, the follo-
wing message will be shown:
KEYPAD OPERATIONS
001
002
180
9