Teleserv. Param; Teleserv. Option; Init.teleservice; Maintenance Call - Bentel Security KYO 320 Installation Manual

nance call or Vigilance call, then press ENTER and
refer to the respective paragraph.
n Num. teleservice
Tel.numb. n.
Number 1
4a. Enter the ID number of the required Teleservice
number, then press ENTER. To go back to the Teleser-
vice menu (step 3), press ESC.
Tel. numb.n. ---
None
5a. Using A or B, select the Telephone number (from
the Phonebook) for the Teleservice facility, or enter the
relevant ID number (enter three zeros to disable the Te-
leservice number). The ID number of the selected Te-
lephone number will be shown on the top right of the
display, and the Description on the bottom line. Press
ENTER to go back to step 4a.
n Teleserv. param.
Customer code
Code
4b. Enter the Customer code that will identify the Con-
trol panel during Teleservice operations 4 digits requi-
red), then press ENTER.
Attempts
Number 08
5b. Enter the number of times the Control panel must
dial a Teleservice number before aborting the call and
going to the next number (refer to "Attempts"), then
press ENTER.
First test date
00:05 01/01/2005
6b. Enter the time and date of the First test, then press
ENTER.
Rep.test event
Hours 0024
7b. Enter the time (hours) that must elapse between
tests (refer to "Repeat test event"), then press ENTER
to go back to step 3.
n Teleserv. option
4c. Using A or B, select: Callback, En. test call, En.
test event or Double call. Refer to the relevant para-
graph for instructions
Callback

Teleserv. option

Callback
36
-
5c. Press ON or OFF, respectively, to enable or disable
the Callback option. If this option is enabled, the Con-
trol panel will call the programmed Teleservice num-
bers when it receives a Teleservice call. Press ENTER
to go back to step 3.
En. test call
Teleserv. option
En.test call
5d. Press ON or OFF, respectively, to enable or disable
the Test call. If this option is enabled, the Control panel
will make the Teleservice call in accordance with the
First test and Repeat test event values. Press ENTER
to go back to step 3.
En. test event
Teleserv. option
En. Test event -
5e. Press ON or OFF, respectively, to enable or disable
the Test Event, then press ENTER to go back to step 3.
Double call
Teleserv. option
Double call
5f. Press ON or OFF, respectively, to enable or disable
the Double call. If this option is enabled, the Control pa-
nel will override any other Answering devices, and an-
swer incoming calls on the first ring (refer to "Double call
sequence" in the INSTALLATION MANUAL). Press
ENTER to go back to step 3.
n Init. teleservice

Init.teleservice

Confirm?
4g. Press ENTER to initialise the First test and Repeat
test events.
Init.teleservice
Done!
The display will show a confirmation message before
going back to step 3.
n Maintenance call
Inst.maint.date
Disabled
4h. Enter the time and date of the Installer Maintenance
Request (enter all zeros to disable this option), then
press ENTER.
Description
Cent.Stat.call
-
-
KYO320