Bpi Peripherals - Bentel Security KYO 320 Installation Manual

Ter. DESCRIPTION
OC2 Programmable
(Open-Collector)
OC3 Programmable
(Open-Collector)
AS 10 KWBalance Tamper Line
L1 Programmable Input Line
:
L8
+F Power supply to detectors (posi-
tive), protected by fuse (will be
powered by the battery during
Mains failure)
BPI1 1° branch of the BPI bus for the

BPI peripherals:

+ = positive protected by fuse
C = Command
R = Response
– = Negative
BPI2 2nd branch of the BPI bus for the
BPI peripherals:
+ = positive protected by fuse
C = Command
R = Response
– = Negative
KEY BUS:
RED positive protected by fuse
BLK negative
YEL Receiver 1
Receiver 2
YEL2
GRN data
- Earth Terminal
LE External telephone line terminals
LI Line-sharing devices terminals (for
Answerphone, telephone, fax, mo-
dem, etc.)
n BPI Peripherals
The terminals shown in the following table are common
to all BPI peripherals.
Ter. DESCRIPTION
+ Power supply: positive
+ C R –
+ C R –
BPI device
Figure 10 Connection of 4 BPI Devices
18
v(V) I(A)
Output no. 5 0
Output no. 6 0
–
–
13.8 3(1)
13.8 3(1)
13.8 3(1)
13.8
0
–
–
v(V) I(A)
13.8
Panel
+ C R –
BPI device
Ter.
1 C Command
R Response
1 – Power supply: negative
–
–
Keypad Keypad have the common BPI bus connection
terminals, and PREMIUM keypad only the following ter-
minals.
Ter.
+F Power supply to Detectors (posi-
tive), protected by resettable fuse
T1 Programmable Input or output Line
(according to M-in/out expander
functioning)
T2 Programmable Input or output Line
(according to M-in/out expander
functioning)
T3 Programmable Input or output Line
(according to M-in/out expander
functioning)
Input Expanders The M-IN/OUT Input/Output Ex-
pander has the following terminals (besides the termi-
0.5
nals for connecting to the BPI).
(1)
Ter.
+F Power supply (positive) protected
by a self-resetting fuse
T1 Input or Output zones depending
–
: on the operating mode of the Ex-
–
T6 pander
–
M Power supply (negative) for the
devices connected to the Ex-
pander
Output Expanders Output Expanders have the com-
mon BPI bus connection terminals, and the following
terminals.
(2)
+ +
C R
BPI IN
Power station
DESCRIPTION
DESCRIPTION
DESCRIPTION
C R
BPI OUT
v(V) I(A)
– –
– –
0 –
v(V) I(A)
13.8 0.4
– –
v(V) I(A)
13.8 (3)
– –
0 0,15
+ C R –
BPI device
KYO 320