Program Panel; Configuration; Keypad - Bentel Security KYO 320 Installation Manual

The Program Panel option will allow you to program all
the parameters which determine system operation. Refer
to "PROGRAMMING" in the INSTALLATION MANUAL
for the description of the following parameters:

Configuration:

And-Zone Groups
Zone
Outputs
Partitions
Keys/Card
Code types
Events-Actions
Events setup
Telephone
Voice messages
Teleservice
Options
Scheduler options
From the INSTALLER MENU:
INSTALLER MENU
Event logger
1. Using A or B, select the Program Panel option.
INSTALLER MENU

Program Panel

2. Press ENTER.
INSTALLER MENU
Configuration
3.Using A or B, select the required option. Refer to the
respective paragraph for the programming instructions.
To exit the PROGRAMMING menu, press ESC.
KYO320
PROGRAM PANEL
Configuration
The Configuration section is divided into different pro-
gramming sections: Keypads, Readers, Input expan-
ders, Output expanders, Power stations, Vector-RX
module, Vox board, Print Logger and IP Board
(K-NET):
INSTALLER MENU
Configuration
1.Press ENTER:
Configuration

Keypad

n Keypad
2. Press ENTER:
Keipad
Keypad
3. Using A or B, select the required keypad , then press
ENTER.
Description
Keypad
4. Enter the Keypad label "Editing a text" under "Using
the Keypad"), then press ENTER.
Keypad
Present
5. Press ON to enrol the keypad (Present), then press
ENTER. To unenrol a Keypad (delete from the Configu-
ration), press OFF.
+
You cannot unenrol a keypad during the program-
ming phase. The values shown on the display are
the current values in the Control panel memory.
Keypad
Memo
6. Using A or B, select Memo (refer to "Memo") or
Part. Fast View (refer to "Quick viewing of Partition sta-
tus") or Tamp./ Al. beep (refer to "Tamper /Alarm
Beep") or Disp.pan.mem. or Disp.part.mem. or
EN50131 Comp (Compatibility with EN50131) press
ON or OFF to enable or disable the option concerned,
then press ENTER.
PROGRAM PANEL
N. 001
001
001
N. 001
N. 001
-
17