Program Panel; Enroll Wireless - Bentel Security KYO 320 Installation Manual

Program Panel

The Control panel parameters can be programmed via
keypad, refer to the "PROGRAM PANEL" section for
details and instructions.

Enroll wireless

The Enrol wireless option will allow you to enrol wire-
less devices (detectors and keys), and perform the Pla-
cement Test.
From the Installer menu:
INSTALLER MENU
Event logger
1. Using A or B, select the Enrol wireless option:
INSTALLER MENU
Enrol wireless
2. Press ENTER:
ENROLL WIRELESS
Enrol detectors
+
If the Receiver has not been enrolled, the display
will show the
[WARNING!____/_No Receiver!_].
3. Using A or B, select Enrol detectors, Enrol WLS
keys or WLS Placement Test, then press ENTER.
From Enrol sensors:
ENROL WIRELESS
Zone 281
4. Using A or B, assign the wireless detector to a zone,
then press ENTER:
Zone
Serial #:000000
Enter the Electronic Serial Number (ESN) of the wire-
less detector. The ESN (6 digits) is printed on the back
of each wireless device. This Control panel accepts
6-digit ESNs only. To correct wrong entries, press e
then enter the correct digit. The ESN may comprise he-
xadecimal digits (A, B, C, D, E and F: use A, B, C, D,ON
and OFF, respectively). The ESN will allow the Control
panel to identify the wireless device.
+
NOTE: To unenrol wireless detectors, enter the
ESN 000000 then press ENTER to confirm.
5. Press ENTER.
ENROL WIRELESS
Zone 281
KYO320
following message:
281
KEYPAD OPERATIONS
6. Use A or B to continue enrolling.
Acceptance will be confirmed by the following message:
ENROL WIRELESS
Enrol ok!
When all the wireless detectors have been enrolled,
press ESC to go back to step 3 then, if you want to enrol
wireless keys, select the Enrol WLS Keys option:
Enrol WLS Keys
ENROL WIRELESS
Enrol WLSKey
4a. Press ENTER.
ENROL WIRELESS
Wireless key 001
5a. Using A or B, select the wireless key to be enrolled,
then press ENTER.
Wireless key 001
Serial #: 000000
Wireless keys are enrolled in the same way as wireless
detectors. When you have enrolled all the wireless
keys, press ESC to go back to step 3 then select the
Placement Test option, in order to test the transmis-
sion signal between the Receiver and the wireless de-
tectors. All placements should be tested before
mounting the wireless detectors.
ENROL WIRELESS
Placement test
4b. Press ENTER.
WLSplacementTest
Zone 281
5b. Using A or B, select the zone of the wireless detec-
tor to be tested, then press ENTER.
Wait result...
6b.Activate the wireless detector (refer to "Activating
Wireless Detectors"), then check the Test result on the
display.
Wait result..
Good!
If the result is good, run further tests until you obtain
three consecutive good results. Press ESC to go back
to step 6b. If the result is bad, move the Detector to anot-
her location and repeat the test. Sometimes a matter of a
few inches can correct a Bad result.
If an Error is signalled, enrol the wireless detector again.
To go back to the Installer menu, press ESC.
13