Check Panel - Bentel Security KYO 320 Installation Manual

Check Panel

The Check option from the menu bar of
KYO320 downloading software application
provides two sub-options: Check Panel and
Check Configuration.
Check Panel This option will allow you to view the
real-time status of the Control panel (see Fig. 56).
Entry of a valid User code PIN will allow you to
control the Zones, Outputs and Partitions and view
the Timers and Trouble windows.
To operate on a specific Partition: click on the
Partition concerned then right-click to open a menu
(see Fig. 56) which will allow you to:
D: Disarm; A: Arm Away mode; S: Arm Stay
Mode; I: Instant (Arm Stay 0 Delay Mode) or Re -
set the Partition concerned and Control panel.
To operate on a ALL Partitions: right-click on
the Partition section to open a menu which will al -
low you to:
D: Disarm ALL Partitions; A: Arm ALL Partitions in Away
mode; S: Arm ALL Partitions in Stay mode; I: Arm ALL
Partitions in Instant mode (Stay 0 Delay) or Reset ALL
Partitions and Control panel.
To operate on a specific Zone:
right click on the Partition the
Zone belongs to, then right-click
to open a menu which will allow
you to: Bypass; Unbypass or
view the real-time analogue
value of the Zone. To control an
Output: right-click on the Output concerned to open a menu
which will allow you to turn the Output ON or OFF.
About the function buttons (un -
der User PIN field)
Clicking on the first button
will open a menu which will
allow you to disable display of real-time status
data (enabled at default) regarding the Zones, Parti -
tions, Trouble, Outputs and Timers.
Clicking on the second button will open
a menu with the following options: Show
violated zones only; Audible signalling
(Beep); Clear manually.
Clicking on the third button will allow you
to enable "Test" mode on ALL Zones.
Clicking on the fourth button will allow
you to disable "Test" mode on ALL
Zones.
Clicking on the fifth button will allow you
to Reset "Programming from PC" Trou -
ble.
Clicking on the sixth button will close the
window.
KYO320
Figure 56 Check Configuration Window
Check Configuration This option will allow you to
view the status of the Control panel peripherals in either
Test mode or Graphic mode (see Fig.57).
Graphic mode: The real-time status of each peripheral
will be indicated by the colour of its icon, as follows:
r Green: the peripheral concerned is in the configura-
tion and operating properly.
r Red: the peripheral concerned is in the configuration
but is in Tamper status (e.g. Frontplate open).
r Yellow: the peripheral concerned is in the configura -
tion but is missing.
r Orange: the peripheral concerned is in the configu -
ration but has the same address as another periph -
eral of the same type (Duplicated peripheral).
r White: the peripheral concerned is not included in
the configuration.
+
In Test mode the real-time status of each peripher-
als will be indicated by the colour of the virtual LED
located next to it.
Figure 55 Check panel Window
PROGRAMMING 87