On-Site Downloading; Firmware Upgrade; Remote Downloading - Bentel Security KYO 320 Installation Manual

Ø dd/mm/yyyy = day/month/year
Ø mm/dd/yyyy = month/day/year
Ø yyyy/mm/dd = year/ month/day

On-site downloading

Once the operating parameters have been set up, they must
be downloaded to the Control Panel concerned, as follows.
+
Access to Programming requires the Installer
Code PIN.
1. Connect the Control Panel serial port (24) to one of
the PC serial ports, as follows:
– using a CVSER/9F9F link (accessory item), or a
cable similar to the one in Figure 51a, connect the
Control Panel to the PC;
– if the PC serial port has 25 pins, use an
ADSER/9M25F adapter (accessory item), or a ca-
ble similar to the one in Figure 51b.
2. Select the PC serial port used for connection with
the Control panel, as follows:
– select Serial Ports from the Settings menu;
– select the serial port (Control Panel section);
– select the number of attempts (Attempts box)
and Baud Rate;
– click Download (Baud Rate section) or OK.
3. Select the parameters to be downloaded, as fol-
lows:
– select Parameters from the Settings menu;
– enter a valid Installer code in the Installer code
field;
–select the Control panel type from the Panel type
menu;
–select the relevant firmware release from the
Firmware Release menu;
– click OK.
4. To download a specific page: click the Download
button on the page concerned.
Figure 52 Connecting Window
KYO 320
5. To Download several pages:
+
!
+
For example: – to download all the Configuration re-
lated pages, select Configuration from the Folders
menu; to download All the Pages, select KYO 320 from
the Folders menu.
6. To view the parameters of the connected Control

Firmware Upgrade

Under "Programming Menu" in addition to Upload and
Download item there is Firmware Upgrade.
When a new Firmware is released, a file .hex will be
given to the installer. This file will run after selecting the
"Start" button (see Figure 53). In this fase if the system
goes in black-out or block, it is necessary to check on
"Restore Panel" and click on "Start". To restore the sys-
tem with the default setting call the Service).

Remote Downloading

You can download the programming data via telephone
line, using a B-Mod2 modem, as follows.
Figure 53 Upgrade Firmware window
PROGRAMMING FROM THE PC
– select the required page from the Folders menu,
right click, select Tag (a ü on the page Icon indi-
cates that it will be downloaded);
– repeat the procedure for all the required Pages;
– right click again then select Download.
To download a family of pages, select the root.
If you send the User page with other pages, the
Control panel WILL STORE the Description, En-
abled Partitions, Associated Timers, User Menu
Access and Code type parameters, but WILL NOT
STORE the Available status, Active status, Duress
Code, Patrol Code and Father Code parameters.
If changes to the Descriptions are not shown on the
Keypads, use the Broadcast Keyp.command
from the INSTALLER MENU.
Panel, work carefully through point 4. then select
Upload instead of Download.
85