Setting the Interfaces
Setting Wander Transmit Interface
Setting Wander Transmit Interface
Description:
You can add Wander to a 2 Mb/s or DS1 PDH signal and also to STM-0, STM-1,
Option 200 required
STM-4 or STM-16 SDH signals
for Jitter and option
012 for PDH.
HOW TO:
PDH Wander (2 Mb/s)
1 Set up the PDH transmit interface, choose CLOCK and select the SOURCE
required from the menu. If you select EXTERNAL connect the external source to
the REF IN port on the CLOCK module. See "Setting PDH/DSn Transmit
Interface (option 012) " page 26.
2 Choose JITTER/WANDER
If you wish to add jitter to the PDH signal see "Setting Jitter Transmit Interface "
page 34.
3 Choose WANDER
4 Choose the WANDER MASK setting required.
You can choose the wander modulating frequency and wander amplitude if
If you choose
amplitude is adjusted and controlled according to your wander frequency choice.
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
.
ON
is chosen.
OFF
, you can choose the "spot" wander frequency. The wander
SPOT
.
WANDER