Setting Up Handler Interface; Bin Sorting - Agilent Technologies 4286A User Manual

Repeat the steps above to create BIN2 through BIN9.
4. Secondary Parameters
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Press SEC REJECT MENU .
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Press UPPER LIMIT .
Enter value .
a
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Press LOWER LIMIT .
Enter value .
b
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Press SEC REJECT on OFF to toggle it
NNNNNNNNNNNNNNNNNNNN
Press RETURN to complete the secondary parameter setting.
5. Press
NNNNNNNNNNNNNN
DONE to complete the creation of BIN table.

Setting up Handler Interface

1. Set up the handler interface board. See \Setting up Handler Interface Board" for details
abount the mode.
2. Press , and then
Test Setup
4 5
3. Select
NNNNNNNNNNNNNNNNNNNN
MODE 1 or
The pattern of output signals for BIN sorting can be selected from either Mode 1 or Mode 2.
De nitions in output signals for handler interface vary depending on the mode used. See
\Setting up Handler Interface Board" for details about the mode.
4. Press
NNNNNNNNNNNNNNNNNNNN
RETURN .

BIN Sorting

1. Press
and then,
Test Setup
4 5
2. Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
BIN SORT on OFF to toggle it
When the BIN sort key is ON, measured data outside the limits are output and displayed as
follows:
On-screen Message Showing Corresponding BIN or BIN OUT (if outside preset limits)
Beeper (ON/OFF selectable)
GPIB Command :DATA? BIN
Handler Interface Output
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
HANDLER IF .
NNNNNNNNNNNNNNNNNNNN
MODE 2 .
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
BIN SORT MENU .
NNNNNNNNNNNNNNNNNNNN
ON off .
NNNNNNNNNNNNNNNNNNNN
ON off .
4286A with Chip Handler 4-3