Table of Contents
Advertisement
Setting the Interfaces
Setting SDH THRU Mode
3 Switch the PAYLOAD OVERWRITE enable/disable field to ON. Test functions
are available whilst Payload Overwrite is enabled. Select the
folder and setup as required.
4 Make the SOH+POH OVERWRITE choice required.
The B1, B2 and B3 BIPs are recalculated before transmission.
5 If you wish to add jitter to the STM-0, STM-1, STM-4 or STM-16 signal, see
"Setting Jitter Transmit Interface " page 34.
40
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
TEST FUNCTION
Advertisement
Table of Contents
