Table of Contents
Advertisement
Making Measurements
Making PDH Analysis Measurements
Making PDH Analysis Measurements
Description
G.821, G.826, M.2100, M.2110 and M.2120 analysis results are provided for all
Option 012 is
relevant PDH and PDH Payload error sources. In addition the following results are
required for PDH
provided:
operation.
Cumulative error count and error ratio. Short Term error count and error ratio.
Alarm Seconds
SIG/BIT Monitor. See "Monitoring Signaling Bits " page 120.
1 If SDH is chosen as the interface, set up the Receive Interface and Payload
HOW TO:
required. See "Setting SDH Receive Interface " page 49. If required set up the
Transmit Interface and Payload. See "Setting SDH Transmit Interface " page 29.
2 If PDH is chosen as the interface, set up the PDH receive interface. See "Setting
PDH/DSn Receive Interface (Option 012) " page 47. If required set up the PDH
transmit interface. See "Setting PDH/DSn Transmit Interface (option 012) "
page 26.
3 Press
4 If SDH is chosen as the interface, you can view the analysis results on the
If PDH is chosen as the interface, you can view the analysis results on the
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
to start the measurement.
RUN/STOP
PDH PAYLOAD ERROR ANALYSIS
RESULTS
PDH
ERROR ANALYSIS
RESULTS
display
display.
115
Advertisement
Table of Contents
